Product variants

Perun AB++ Airsoft MOSFET w/ Burst and Active Braking

$55.68 Sold out

Features

Electronic burst
Active brake with adjustable braking power
Pre-cocking with spring release feature
Rate of fire reduction
DMR mode
Low battery voltage alarm
Programming supported with a multicolor LED diode
Diagnostic system & electronic resettable fuse

Electronic burst: Change auto to an electronically controlled burst to save your ammo and increase realism!

Active brake: Active brake stops the motor after each shot preventing spring compression or in case of replicas with high rate of fire, overspin (double shot problem).

Pre-cocking: Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With pre-cocking enabled, the piston will remain in rear position after each shot with the spring already compressed, ensuring that next shot will be fired immediately after you pull the trigger. To release the spring after using pre-cocking, pull the trigger while simultaneously holding button on the unit. A shot will be fired, with no pre-cocking and fully braked.

Rate of fire reduction: Reduce the rate of fire in automatic or burst fire to save ammo or make the replica shoot in a more realistic fashion.

DMR mode: Introduces intervals between semiautomatic shots to comply with DMR rules on some fields.

Low battery voltage alarm: Dedicated for Li-Po and Li-Ion batteries. Should the battery voltage fall to a dangerously low level, user will be notified by short sound signals that are repeated every minute. This may also be freely switched on and off.

Diagnostic system: Constantly monitors the replica and the MOSFET itself. In case of any problems, immediately lets you know what it might be, making troubleshooting much easier.

Electronic fuse: Will save your replica and battery in case of a major malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.